Hawken Settings and Console Commands Guide


Hawken Settings and Console Commands Guide?by ArnieF4440

DISCLAIMER: Tweaking INI?s is not supported by the devs, backup your original files, and ONLY modify the files in DocumentsMy GamesHawkenHawkenGameConfig not your install directory


  • Cockpit Lag ? Delay between you moving the mouse and your mech moving. The higher this slider is, the more authentic the mech will feel, the lesser, the quicker the mech will respond. I prefer to keep this at the minimum possible for the responsiveness [ArnieF4440]
  • Changing FOV: [ArnieF4440]

My GamesHawkenHawkenGameConfigHawkenGame.ini
FOV_Override=[your fov here]

  • My GamesHawkenHawkenGameConfigHawkenSystemSettings.ini <- where all graphical settings are stored. Tweak at your own risk [ArnieF4440]
  • If you wanna disable the F10 Unreal Engine Screenshot keybinding, go to My GamesHawkenHawkenGameConfigHawkenInput.ini and put a comment (using ?;?) before, but on the same line as any line which has F10, or for commands ?TiledShot 3 256?.[ArnieF4440]

Console Commands
You can hit ?T?, ?F6?, or ?~'(tilda) (or whatever your console keybind is) to open up the console. If it has something, just hit backspace until its clear

  • say [your message here] ? ingame message to all
  • teamSay [your message here] ? ingame message to team only
  • stat fps ? shows FPS counter
  • switchteam ? switches team

More console commands can be found here:
But not sure if they all work (give it a shot)

Leave a Reply